Watch The Big Squeegee Cut Vinyl Tool Video

The Big Squeegee Cut Vinyl Tool is an all-in-one tool that can be used to mask and mount cut vinyl as well as for mounting and laminating printed graphics. Both the front and back edges of the Cut Vinyl Tool are covered in a soft replaceable felt that is ideal for masking especially over slightly irregular surfaces.

Apply the transfer tape to the cut vinyl by applying the front edge of the tape to the edge of the vinyl. With the edge of the Cut Vinyl Tool held at a 35-45 degree angle, move the Big Squeegee across the cut vinyl while applying slight pressure toward the application point, not downward. You can place the roll in front of the Cut Vinyl Tool and allow it to roll as you move the tool across the vinyl. For finely cut graphics, you can turn the tool backwards and place the roll in the roll holder (the light green curved piece) and allow the roll to spin on top of the Cut Vinyl Tool. Both techniques are fast and effective. Once the transfer tape is applied, you can remove the release liner from the vinyl and apply the cut vinyl to foam core, corrugated plastic, or any surface you desire. You can do this with the Cut Vinyl Tool or the Big Squeegee Laminator. Then remove the transfer tape and your job is complete.

We recommend that you use a Cut Vinyl Tool that is at least 2" larger than the width of your masking.

Available in 26" and 32" sizes.  Please note the Cut Vinyl Tool shipping box may be labeled as a Tape Applicator.