Ledco Digital 44
Dual Hot Roll Laminator

Ledco Digital
44 Dual Hot Roll

The Dual Hot Roll Digital 44 Laminator is Ledco's newest addition to the digital line. In addition to providing the same capabilities as the Heat Shoe Digital 42" and 60", the Dual Hot Roll Digital 44" offers the freedom to mount in one pass and to simultaneously mount and laminate.

With a top speed of 30 FPM and a sustainable laminating speed of 8-10 FPM the Dual hot roll Digital 44 performs faster than most competitive units. It is easy to thread and has a clear Plexiglas safety shield that provides the operator with visual access to the laminating process.

Standard features include a built-in release liner take-up and stand. the release liner allows for the application of any pressure-sensitive material that requires the removal of a protective liner. The wide range of temperatures available make this laminator perfect for almost any application up to 44" wide. The Dual Hot Roll Digital 44" will process thermal film, all pressure-sensitive materials, pre-mask, and mounting materials.

Standard Features and Benefits:

• Quality silicone rubber laminating rollers release materials easily and maintain their flexibility for a good edge seal.
• Two sets of rollers keep the film flat and tight while heat laminating so that the automatic fans cool and set the adhesive. When thermal films cool in a slack state, the surface of the lamination is wavy and rippled.
• Supply roll tension is easy to adjust by simply tightening or loosening the tension control knobs on the supply roll mandrels.
• Variable speed allows thinner films to be run faster, and enables mounting or the use of thicker films, which require slower speeds.
• Independent temperature controls for top and bottom heaters allow the use of different materials on front and back of an image.
• Large feed tray makes it easier to handle big graphics. The pressure strip next to the nip helps keep images flat and wrinkle-free.
• Extruded aluminum stand with casters.
• Made in the U.S.A. All parts, including motors and controls, are made here as well.

• Roll feed assembly. The lamination of long images or rolls of images is simplified by a roll feed process. It is difficult to keep long graphics going straight if they are fed from a table. Rolling the material up on an empty core and feeding from a tensioned supply roll with an idler bar insures the material will stay flat and straight from beginning to end.
• Slitters remove the side scrap from both sides of each sheet as it goes through the laminator. This greatly reduces the amount of time required for trimming.
• Precision Feed Table consists of several plates that can be adjusted horizontally to act as both left and right side feed guides. This ensures that substrates of varying widths are fed into the laminator straight. This is an excellent option if you will be laminating multiple sheets of a single size when it is essential that your prints are laminated perfectly straight. When combined with the slitter assembly, the Precision Feed table provides professional results in half the time by eliminating the need to trim excess laminate from two sides of your print.

BACK TO TOP